LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Fusion S, Standard Trans >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Power Brake Actuation - Brake Booster >> Removal And Installation >> Brake Booster Vacuum Sensor - Non-Hybrid

Brake Booster Vacuum Sensor - Non-Hybrid

  1. Remove the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Remove the 2 brake fluid remote reservoir nuts and position the reservoir aside.
    • To install, tighten the nuts to 7 Nm (62 lb-in).
  3. Disconnect the vacuum sensor electrical connector and remove the vacuum sensor.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals