Resonator

Resonator - 3.5L

Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist.

2. Remove and discard the 2 exhaust Y-pipe-to-resonator nuts.
- Discard the gasket.

- To install, tighten to 40 Nm (30 lb-ft).


3. Loosen Torca(R) clamp nut.
- To install, tighten to 47 Nm (35 lb-ft).


4. Separate the resonator from the muffler and tail pipe and remove the resonator.

5. To install, reverse the removal procedure.
- Install a new gasket and nuts.


6. Start the engine and check for exhaust leaks.