LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Focus S, Standard Trans, Gas >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Dual Clutch Transaxle (DCT) POWERSHIFT (DPS6/6DCT250) - External Controls) >> Removal and Installation >> Selector Lever Knob >> Removal

Selector Lever Knob: Removal

WARNING: This page is about a different variant/trim than selected.
WARNING: Before beginning any service procedure in this service information, refer to Safety Warnings in SERVICE INFORMATION General Information. Failure to follow this instruction may result in serious personal injury.
NOTE: The O/D  cancel switch and the SelectShift™ switch are part of the selector lever knob. To install a new O/D  cancel switch or SelectShift™ switch, a new selector lever knob must be installed.
  1. Refer to: Health and Safety Precautions  ( HEALTH AND SAFETY PRECAUTIONS .
  2. Fig 1: Removing Center Console Trim Panel
    G08065647Courtesy of FORD MOTOR CO.
  3. Fig 2: Removing Selector Lever Trim
    G08064480Courtesy of FORD MOTOR CO.
  4. Fig 3: Locating Selector Lever Cable Connector
    G08064481Courtesy of FORD MOTOR CO.
  5. Fig 4: Locating Selector Lever Fasteners
    G08064482Courtesy of FORD MOTOR CO.
  6. Fig 5: Removing Selector Lever Cover
    G08064483Courtesy of FORD MOTOR CO.