LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Focus S, Standard Trans, Gas >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Dual Clutch Transaxle (DCT) POWERSHIFT (DPS6/6DCT250) - External Controls) >> Removal and Installation >> Selector Lever Assembly >> Removal

Selector Lever Assembly: Removal

WARNING: This page is about a different variant/trim than selected.
WARNING: Before beginning any service procedure in this service information, refer to Safety Warnings in SERVICE INFORMATION General Information. Failure to follow this instruction may result in serious personal injury.
NOTE: Removal steps in this procedure may contain installation details.
  1. Refer to: Health and Safety Precautions  ( HEALTH AND SAFETY PRECAUTIONS .
  2. Refer to: Floor Console - Vehicles With: Center Armrest  ( FLOOR CONSOLE - VEHICLES WITH: CENTER ARMREST ).

    Refer to: Floor Console - Vehicles Without: Center Armrest  ( FLOOR CONSOLE - VEHICLES WITHOUT: CENTER ARMREST ).

  3. Fig 1: Disconnecting Selector Lever Cable End
    G08064444Courtesy of FORD MOTOR CO.
  4. Fig 2: Locating Selector Lever Electrical Connector
    G08064445Courtesy of FORD MOTOR CO.
  5. Torque  : 9 Nm
    Fig 3: Locating Selector Lever Bracket Bolts
    G08064446Courtesy of FORD MOTOR CO.
  6. Torque  : 9 Nm
    Fig 4: Locating Selector Lever Assembly Bolts
    G08064447Courtesy of FORD MOTOR CO.