Selector Lever Cable Adjustment

WARNING: This page is about a different variant/trim than selected.

WARNING: Before beginning any service procedure in this service information, refer to Safety Warnings in SERVICE INFORMATION General Information. Failure to follow this instruction may result in serious personal injury.

Refer to: Health and Safety Precautions ( HEALTH AND SAFETY PRECAUTIONS .
Fig 1: Sliding Selector Lever Cable End Upward
Courtesy of FORD MOTOR CO.
Fig 2: Identifying Selector Lever Position
Courtesy of FORD MOTOR CO.
Fig 3: Unlocking Lock Tab On Selector Lever Cable
Courtesy of FORD MOTOR CO.
NOTE: Position the selector shaft lever in the (D) position.
1. Set the selector lever to the (D) position.
2. Visual check.
Fig 4: Checking Selector Shaft Lever Position
Courtesy of FORD MOTOR CO.
Fig 5: Locking Selector Lever Cable Lock Tab
Courtesy of FORD MOTOR CO.
Verify that the vehicle only starts in PARK and NEUTRAL and the reverse lamps illuminate in REVERSE.