Output Shaft Speed (OSS) Sensor: Installation

WARNING: This page is about a different variant/trim than selected.

1. 2. Material : Motorcraft® Dual Clutch Transmission Fluid / XT-11-QDC (WSS-M2C200-D2)
Fig 1: Lubricating Output Shaft Speed (OSS) Sensor Seal Ring
Courtesy of FORD MOTOR CO.
NOTE: Make sure that the surface is clean and free of foreign material before taping around the component.

Fig 2: Applying Protective Material To Connector (1 Of 7)
Courtesy of FORD MOTOR CO.
Fig 3: Applying Protective Material To Connector (2 Of 7)
Courtesy of FORD MOTOR CO.
Fig 4: Applying Protective Material To Connector (3 Of 7)
Courtesy of FORD MOTOR CO.
Fig 5: Applying Protective Material To Connector (4 Of 7)
Courtesy of FORD MOTOR CO.
Fig 6: Applying Protective Material To Connector (5 Of 7)
Courtesy of FORD MOTOR CO.
Fig 7: Applying Protective Material To Connector (6 Of 7)
Courtesy of FORD MOTOR CO.
Fig 8: Applying Protective Material To Connector (7 Of 7)
Courtesy of FORD MOTOR CO.