Valve Tappets: Removal

WARNING: This page is about a different car, the 2013 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces, that enters the oil passages, coolant passages or the oil pan can cause engine failure.

NOTE: If the camshafts and valve tappets are to be reused, note the location of the valve tappets to make sure they are assembled in their original positions.

NOTE: Removal steps in this procedure may contain installation details.

Refer to: JACKING AND LIFTING - OVERVIEW .
Refer to: Camshaft .
Apply the specified lubricant to the specified component.
Material : Motorcraft® SAE 5W-30 Premium Synthetic Blend Motor Oil / XO-5W30-QSP (WSS-M2C946-A)

Fig 1: Lubricating Valve Tappets With Clean Engine Oil
Courtesy of FORD MOTOR CO.
NOTE: The number on the valve tappets only reflects the digits that follow the decimal. For example, a tappet with the number 0.650 has the thickness of 3.650 mm.
- Visual check.
- Install new components as necessary.
Fig 2: Inspecting Valve Tappet
Courtesy of FORD MOTOR CO.