LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Focus S, Standard Trans, Gas >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Engine Mechanical - 2.0L ECOBOOST) >> Removal and Installation >> Valve Stem Seals >> Removal

Valve Stem Seals: Removal

WARNING: This page is about a different car, the 2013 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: During engine repair procedures, cleanliness is extremely important. Any foreign material (including any material created while cleaning gasket surfaces) that enters the oil passages, coolant passages or the oil pan can cause engine failure.
  1. Refer to: JACKING AND LIFTING - OVERVIEW .
  2. Refer to: Valve Springs  .
  3. Discard the specified component. Follow local disposal regulations.

    Special Tool(s)  : 303-468 (Remover, Valve Stem Oil Seal)  , 307-005 (Slide Hammer) 

    Fig 1: Removing Valve Stem Seals
    G08063215Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals