LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Focus S, Standard Trans, Gas >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Electronic Engine Controls - 2.0L ECOBOOST) >> Removal and Installation >> Front Knock Sensor (KS) >> Removal

Front Knock Sensor (KS): Removal

WARNING: This page is about a different car, the 2013 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Removal steps in this procedure may contain installation details.
    WARNING: Before beginning any service procedure in this service information, refer to Safety Warnings in SERVICE INFORMATION General Information. Failure to follow this instruction may result in serious personal injury.
  1. Refer to: Health and Safety Precautions  ( HEALTH AND SAFETY PRECAUTIONS ).
  2. Refer to: Intake Manifold  ( INTAKE MANIFOLD .
  3. NOTE: Note the position of the component before removal.
    NOTE: Make sure that the component is installed to the position noted before removal.
    Fig 1: Locating Front Knock Sensor Harness Connector
    G08063990Courtesy of FORD MOTOR CO.
  4. Torque  : 20 Nm