Cylinder Head Temperature (CHT) Sensor: Removal

WARNING: This page is about a different car, the 2013 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Removal steps in this procedure may contain installation details.

WARNING: Before beginning any service procedure in this service information, refer to Safety Warnings in SERVICE INFORMATION General Information. Failure to follow this instruction may result in serious personal injury.

Refer to: Health and Safety Precautions ( HEALTH AND SAFETY PRECAUTIONS ).
Remove the air cleaner outlet pipe and the turbocharger inlet pipe. Refer to AIR CLEANER OUTLET PIPE .
Fig 1: Removing Air Cleaner Outlet Pipe And Turbocharger Inlet Pipe
Courtesy of FORD MOTOR CO.
Discard the specified component. Follow local disposal regulations.
Torque : 10 Nm

Fig 2: Removing Cylinder Head Temperature (CHT) Sensor
Courtesy of FORD MOTOR CO.