LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Focus S, Standard Trans, Gas >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brake System - General Information - Except Electric >> General Procedures >> Component Bleeding

Component Bleeding

SPECIAL TOOL(S) / GENERAL EQUIPMENT

Fluid Container
MATERIALS SPECIFICATIONS

Name Specification
Motorcraft® DOT 4 LV High Performance Motor Vehicle Brake Fluid
PM-20		 WSS-M6C65-A2
ISO 4925 Class 6
NOTE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or plastic surface, immediately wash the surface with water.
NOTE: Brake Master Cylinder
    WARNING: Before beginning any service procedure in this service information, refer to Safety Warnings in SERVICE INFORMATION General Information. Failure to follow this instruction may result in serious personal injury.
  1. Refer to: HEALTH AND SAFETY PRECAUTIONS .
  2. Disconnect the brake tubes from the master cylinder.
  3. Install brake master cylinder bleed tubes onto the primary and secondary ports with the ends of the tubes submerged in the brake master cylinder reservoir.
  4. Fill the brake master cylinder reservoir with clean, specified brake fluid.

    Material  : Motorcraft® DOT 4 LV High Performance Motor Vehicle Brake Fluid / PM-20 (WSS-M6C65-A2) (ISO 4925 Class 6)

  5. Have an assistant pump the brake pedal until clear fluid flows from the brake tubes without air bubbles.
  6. Remove the brake master cylinder bleed tubes, install the master cylinder brake tubes and tighten the brake tubes to specification.

    Refer to: Specifications  .

  7. Bleed the brake system.

    Refer to: Brake System Bleeding  .

NOTE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or plastic surface, immediately wash the surface with water.
NOTE: Brake Caliper or Wheel Cylinder
NOTE: It is not necessary to do a complete brake system bleed if only a brake caliper, wheel cylinder or brake hose was disconnected or replaced.
    WARNING: Before beginning any service procedure in this service information, refer to Safety Warnings in SERVICE INFORMATION General Information. Failure to follow this instruction may result in serious personal injury.
  1. Refer to: HEALTH AND SAFETY PRECAUTIONS .
  2. Clean all the dirt from around the brake fluid reservoir cap and remove the cap. Fill the brake master cylinder reservoir with clean, specified brake fluid and reinstall the fluid reservoir cap.

    Material  : Motorcraft® DOT 4 LV High Performance Motor Vehicle Brake Fluid / PM-20 (WSS-M6C65-A2) (ISO 4925 Class 6)

  3. Remove the bleeder cap and place a box-end wrench on the bleeder screw. Attach a rubber drain tube to the bleeder screw and submerge the free end of the tube in a container partially filled with clean, specified brake fluid.

    General Equipment  : Fluid Container

  4. Have an assistant pump the brake pedal and then hold firm pressure on the brake pedal.
    • Loosen the bleeder screw.
    • Leave open until clear, bubble-free brake fluid flows, then tighten the bleeder screw.
    • For rear integral parking brake calipers, apply and release the parking brake 5 times while bleeding the rear brake caliper.
    • Repeat until clear, bubble-free fluid comes out.
  6. Remove the rubber hose and tighten the bleeder screw to specification and install the bleeder screw cap.

    Refer to: Specifications  .

  7. Fill the brake master cylinder reservoir with clean, specified brake fluid and install the fluid reservoir cap.

    Material  : Motorcraft® DOT 4 LV High Performance Motor Vehicle Brake Fluid / PM-20 (WSS-M6C65-A2) (ISO 4925 Class 6)

scientia non olet · About LEMON Manuals