LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Focus Electric >> Repair and Diagnosis >> External Pages >> Different car >> Section 560 (Exhaust System - 2.0L DURATEC-He (125KW/170PS) - Mi4 (Except Electric Vehicle)) >> Diagnosis And Testing >> Exhaust System >> Symptom Chart(s) >> Symptom Chart: Symptom Chart - Exhaust System

Symptom Chart: Symptom Chart - Exhaust System

WARNING: This page is about a different car, the 2016 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.

Diagnostics in this service information assume a certain skill level and knowledge of Ford-specific diagnostic practices. for information regarding Ford-specific diagnostic practices.

Verify the customer concern and then inspect the components of the exhaust system for obvious signs of damage or other mechanical concerns using the following chart.

Visual Inspection Chart - Mechanical 

Mechanical
Exhaust pipe pinched or crushed
Damaged muffler
Broken or damaged exhaust hanger brackets
Damaged catalytic converter
Cracked exhaust manifold
Loose or damaged heat shields

Verify the exhaust system is installed correctly, with clamps correctly located and tightened to specifications. If the fault is not visually evident, determine the symptom. GO to Symptom Chart below or

Symptom Chart 

Condition Possible Sources Actions
Vehicle has low or no power - vehicle performance complaint Exhaust pipe pinched or crushed
Damaged catalytic converter
Loose obstruction in exhaust
REFER to the ENGINE CONTROLS - INTRODUCTION (EXCEPT DIESEL & HYBRID)
Restricted exhaust (possible frozen condensate in muffler) CHECK drain holes for foreign material. PARK the vehicle inside to thaw. TEST the vehicle for normal operation. If the concern is still present, REFER to ENGINE CONTROLS - INTRODUCTION (EXCEPT DIESEL & HYBRID)
Burning smell - usually occurs at idle, with possible traces of smoke Foreign material caught in exhaust system
Missing heat shields
INSPECT the exhaust system for foreign material or missing heat shields. REPAIR or INSTALL new components as necessary. TEST the system for normal operation after the repair.
Odor - described as a sulfur or rotten egg smell Catalytic converter
Excessive sulfur content in fuel
At times, a slight sulfur smell is normal for catalytic converters. The cause is the sulfur content in the gasoline being used. ADVISE the customer no repair is required.
Rich fuel conditions
Misfire conditions
REFER to ENGINE CONTROLS - INTRODUCTION (EXCEPT DIESEL & HYBRID)
Visible rust on surface of exhaust pipes Catalytic converter/exhaust system Surface rust is a characteristic of materials used on exhaust systems. Exposure to heat or road salt may result in surface rust. INSPECT for perforations. If there are no perforations, the condition is normal.