Fuel Lines: Removal
WARNING: This page is about a different car, the 2015 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Before beginning any service procedure in this service information, refer to Safety Warnings in GENERAL INFORMATION
. Failure to follow this instruction may result in serious personal injury.
- 2.
Release the fuel system pressure. Refer to: Fuel System Pressure Release .
- 3.
Remove the battery tray. Refer to: Battery Tray .
- 4.
- Disconnect the fuel jumper tube-to-fuel injection pump spring lock coupling.
- Disconnect the EVAP vapor tube quick release coupling.
- Disconnect the fuel pressure sensor electrical connector.
- Disconnect the front brake tube fitting-to-middle brake tube fitting.
Torque
: 133 lb.in (15 Nm)
- Detach the clip.
- 5.
Remove the crossmember support crossbrace.- Remove the crossmember support bracket-to-body bolts.
Torque
: 35 lb.ft (47 Nm)
- Remove the crossmember support bracket nuts.
Torque
: 35 lb.ft (47 Nm)
- Remove the crossmember support bracket-to-body bolts.
- 6.
Remove the RH crossmember support bracket.- 1.
Remove and discard the RH subframe rearward bolt.Torque:
Stage 1: 103 lb.ft (140 Nm)
Stage 2: 180°
- 2.
Remove the crossmember support bracket-to-body bolts.Torque
: 46 lb.ft (62 Nm)
- 1.
- 8.
- Disconnect the fuel supply tube and EVAP vapor tube quick release coupling. Refer to: Quick Release Coupling .
- Disconnect the middle brake tube fitting-to-rear brake tube fitting.
Torque
: 133 lb.in (15 Nm)