Ignition Coil-On-Plug: Removal

WARNING: This page is about a different car, the 2015 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Before beginning any service procedure in this service information, refer to Safety Warnings in GENERAL INFORMATION . Failure to follow this instruction may result in serious personal injury.

NOTE: Removal steps in this procedure may contain installation details.

1.

Refer to: Health and Safety Precautions .

2.

If equipped, remove the engine cover.

3.

NOTE: Use compressed air to remove any foreign material from the ignition coil-on-plug and surrounding area before removing the ignition coil-on-plug.

Disconnect the 4 ignition coil-on-plug electrical connectors.

4.

Remove the 4 ignition coil-on-plug bolts.
Torque

: 89 lb.in (10 Nm)

5.

NOTE: When removing the ignition coil-on-plugs, a slight twisting motion will break the seal and ease removal.

NOTE: When installing apply a small amount of silicone brake caliper grease and dielectric compound to the inside of the ignition coil-on-plug boots before installation.

Remove the 4 ignition coil-on-plugs.

Material

: Silicone Brake Caliper Grease and Dielectric Compound / XG-3-A (ESE-M1C171-A)