Valve Stem Seals: Removal
WARNING: This page is about a different car, the 2015 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces, that enters the oil passages, coolant passages or the oil pan can cause engine failure.
- 1.
Remove the valve spring. REFER to: Valve Springs .
- 2.
- Position the Valve Stem Oil Seal Remover and the Slide Hammer over the seal.
Use Special Service Tool: 303-468 (T94P-6510-AH) Remover, Valve Stem Oil Seal, 307-005 (T59L-100-B) Slide Hammer.
- Pull up on the Slide Hammer and remove the seal.
- Discard the valve seal.
- Position the Valve Stem Oil Seal Remover and the Slide Hammer over the seal.