Input Shaft Seal: Removal
WARNING: This page is about a different car, the 2015 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.
- 1.WARNING: Before beginning any service procedure in this article, refer to Health and Safety Precautions . Failure to follow this instruction may result in serious personal injury.
Refer to: Health and Safety Precautions .
- 2.
Remove the transmission. Refer to: Transmission - 2.0L EcoBoost (184kW/250PS) - MI4 .
- 4.NOTE: Take extra care not to damage the bearing.
Using a punch, poke a hole in the input shaft seal.
- 5.
- 1.
Using a 2.5 x 15 mm self-tapping screw, thread a 2.5 x 15 mm self tapping screw into the input shaft seal 2 complete turns.
- 2.
Using a pair of pliers, pull on the screw and remove the seal.
- 1.