Pinpoint Test Ai: The Turn Signal-Hazard On Chime Is Inoperative

AI1 CHECK THE SAFETY BELT WARNING CHIME OPERATION
- Ignition OFF.
- Ignition ON.
- Monitor the safety belt warning chime when the ignition is transitioned from OFF to RUN for 6 seconds.
Does the safety belt warning chime operate for approximately 6 seconds?
1. Yes : GO to AI2
2. No : INSTALL a new IPC .
  REFER to: Instrument Panel Cluster (IPC) .
AI2 CHECK THE TURN SIGNAL INDICATOR OPERATION
- Verify the RH and LH turn signal indicators operate correctly.
Do the turn signal indicators operate correctly?
1. Yes : GO to AI3
2. No : GO to PINPOINT TEST J
AI3 PERFORM THE BODY CONTROL MODULE (BCM) SELF-TEST
- Using a scan tool, perform the BCM self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?
1. Yes : REFER to: BODY CONTROL MODULE (BCM) .
2. No : INSTALL a new IPC .
  REFER to: Instrument Panel Cluster (IPC) .