LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Focus Electric >> Repair and Diagnosis >> Brakes >> Parking Brake System - Parking Brake & Actuation -- Electric >> Diagnosis and Testing >> Parking Brake >> Pinpoint Tests >> The Parking Brake Does Not Apply Or Does Not Hold Vehicle >> Pinpoint Test A: The Parking Brake Does Not Apply Or Does Not Hold Vehicle

Pinpoint Test A: The Parking Brake Does Not Apply Or Does Not Hold Vehicle

  1. A1 CHECK THE PARKING BRAKE CONTROL 
    • Pull up the parking brake control handle.

    Does the parking brake control move? 

    • Yes  : GO to A2 
    • No  : GO to  A3
  2. A2 INSPECT THE FOLLOWING PARKING BRAKE COMPONENTS 
    NOTE: Have an assistant pull and release the parking brake to help isolate disconnected cables or cables that do not move.
    • Parking brake control
    • Front parking brake cable
    • Rear parking brake cables and/or equalizer
    • Rear brake caliper actuators

    Is any damage found or are any components disconnected? 

    • Yes  : CONNECT the component(s) or INSTALL new parking brake component(s) as necessary. TEST the system for normal operation. ADJUST the parking brake cables. Parking Brake Cable Adjustment - Disc Brakes

      REFER to: PARKING BRAKE CABLE ADJUSTMENT - VEHICLES WITH: REAR DISC BRAKES .

    • No  : VERIFY that the rear pads and brake discs are within thickness specifications.

      REFER to: SPECIFICATIONS .

      If the rear pads and brake discs are OK, INSTALL new rear brake caliper(s). REFER to: BRAKE CALIPER .

  3. A3 ISOLATE THE PARKING BRAKE CONTROL AND FRONT PARKING BRAKE CABLE 
    • Disconnect the front parking brake cable from the rear parking brake cable equalizer.
    • Pull up the parking brake control handle.

    Does the parking brake control handle move? 

    • Yes  : GO to A4 
    • No  : INSTALL a new parking brake control or a new front parking brake cable as necessary.

      REFER to: PARKING BRAKE CONTROL .

      TEST the system for normal operation.

  4. A4 ISOLATE THE REAR PARKING BRAKE CABLES 
    • Disconnect the rear parking brake cable from the rear brake caliper at the affected wheel end(s).
    • While holding the cable conduit, attempt to slide the cable inside the conduit.

    Does the cable slide freely inside the conduit?