General Procedure

NOTE: These procedures apply to both wire-formed and stamped D-ring designs.

If necessary, remove the appropriate B, C or D-pillar trim panel:
REFER to B-PILLAR TRIM PANEL .

REFER to C-PILLAR TRIM PANEL - WITH INFLATABLE SAFETY BELTS , or

REFER to C-PILLAR TRIM PANEL - WITHOUT INFLATABLE SAFETY BELTS .

REFER to D-PILLAR TRIM PANEL .
NOTE: Typical D-ring shown in illustration, others similar.

Grasp the safety belt webbing at the D-ring and fold the twisted portion of the belt webbing over itself.

Fig 1: View Of Folding Twisted Portion Of Belt Webbing Over Itself
Courtesy of FORD MOTOR CO.
Feed the folded portion of the safety belt webbing through the D-ring to remove the twist from the belt webbing.

Fig 2: Feeding Folded Portion Of Safety Belt Webbing Through D-Ring
Courtesy of FORD MOTOR CO.