Safety Belt System - 3rd Row: Overview

WARNING: After a crash, all of the following second and third row safety belt components and attaching hardware must be inspected and tested to verify correct function:

Retractors
Buckles
Child safety seat tether bracket assemblies
ALR feature for child safety seats (passenger seating positions only)
Inflatable safety belt systems

Components that do not operate correctly or pass all Functional Tests in the Component Tests of this section must be replaced with new components.

Safety belt assembly attaching areas must be inspected. Damaged or distorted attaching areas must be restored to their original structural integrity and a new safety belt assembly with new attaching hardware must be installed.

Deployed inflatable safety belts must be replaced with new inflatable components (including retractors, buckles and inflators) and all parts in the service kit.

Failure to install new safety belt systems and attaching hardware increases the risk of serious personal injury or death in a crash.

The third row safety belts are continuous-loop, 3-point systems. The combination lap and shoulder belt (continuous-loop) uses a common slip tongue and retractor.

When replacing safety belt buckles and/or retractor assemblies, use only the replacement parts specified in the Ford Catalog Advantage or equivalent.