Component Test

WARNING: After a crash, the following safety belt components and attaching hardware must be inspected and tested to verify correct function:

Retractors
Buckles
Child safety seat tether bracket assemblies
ALR feature for child safety seats (passenger seating positions only)
BTS (if equipped)
Front safety belt buckle support assemblies (slide bar) (if equipped)
Safety belt shoulder belt height adjusters (if equipped)

Components that do not operate correctly or pass all Functional Tests in the Component Tests of this section must be replaced with new components.

Safety belt assembly attaching areas must be inspected. Damaged or distorted attaching areas must be restored to their original structural integrity and a new safety belt assembly with new attaching hardware must be installed.

After deployment of the front safety belt pretensioners, a new safety belt system (including retractors, buckles and height adjusters) must be installed.

Failure to follow this instruction may result in incorrect operation of the safety belt system and increases the risk of serious personal injury or death in a crash.

WARNING: The driver and passenger must be prepared to brace themselves in the event the safety belt retractor does not lock. Failure to follow this instruction may result in serious personal injury.

NOTE: Make sure there is no excessive slack in the safety belt webbing across the torso during testing.

NOTE: Do not jerk on the safety belt webbing when carrying out this test.

Move the seat in front of the seating position being tested as far forward as is safely possible.
Fasten the inflatable safety belts and proceed to a safe area.
Reach a speed of 24 kmh (14.9 mph).
WARNING: Apply maximum brake force only on dry concrete or equivalent hard surface, NEVER on wet pavement or gravel. Failure to follow this instruction may result in serious personal injury.

Grasp the shoulder harness, lean forward and apply the brakes, making a maximum braking application without a skid.
The inflatable safety belt shoulder harness should lock up with minimum webbing extension.
Safely bring the vehicle to a stop.
Pull about 152.4 mm (6 in) of inflatable safety belt lap belt webbing off of the lap. Hold the belt off of the lap.
Reach a speed of 24 kmh (14.9 mph).
WARNING: Apply maximum brake force only on dry concrete or equivalent hard surface, NEVER on wet pavement or gravel. Failure to follow this instruction may result in serious personal injury.

While holding the inflatable safety belt lap belt, apply the brakes, making a maximum braking application without a skid.
The inflatable safety belt lap belt should lock up with minimum webbing extension.
If there is a lockup of all inflatable safety belt retractors being tested, the inflatable safety belt retractors are functioning correctly. If any inflatable safety belt retractor fails to lock up, install a new inflatable safety belt retractor(s).