LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System - General Procedures, Removal And Installation >> Removal And Installation >> Driver Air Bag Module >> Installation

Driver Air Bag Module: Installation

  1. NOTE: The driver air bag module electrical connectors are unique and cannot be reversed when connected to the driver air bag module. Match the electrical connector key to the keyway in the driver air bag module. Do not force the electrical connectors into the driver air bag module. Damage to the connector or component may occur.

    Connect the 2 driver air bag module electrical connectors.

  2. NOTE: Audible clicks will be heard when both wire clips are seated in the driver air bag module.

    Align the driver air bag module locking pins to the steering wheel and, while pushing inward, seat the 2 driver air bag module locking pins to the steering wheel wire clips.

    • When the 2 driver air bag module locking pins are seated, there should be an even gap between the driver air bag module trim cover and the steering wheel.
  3. Repower the SRS. REFER to Supplemental Restraint System (SRS) Depowering and Repowering - with Intelligent Access (IA)  or REFER to Supplemental Restraint System (SRS) Depowering and Repowering - without Intelligent Access (IA) .
scientia non olet · About LEMON Manuals