LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 93 (Fuel Charging System & Fuel Control System - 6.7L) >> Removal And Installation >> Throttle Body >> Installation

Throttle Body: Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using a new TB gasket, install the TB and the 4 bolts.
    • Tighten the 4 TB bolts in a crisscross pattern.
    • Tighten to 10 Nm (89 lb-in).
  2. Connect the TB electrical connector.
  3. Install the CAC outlet tube clip and connect the CAC outlet tube to the Throttle Body (TB).
  4. Perform the PCM adaptive value reset for the TB.
    1. Turn the ignition key ON without cranking the engine.
    2. Turn the ignition key OFF.
    3. Wait 30 seconds for the PCM to reset the adaptive values for the TB.
    4. Start the engine.
scientia non olet · About LEMON Manuals