LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 88 (Engine Ignition - 6.2L) >> Removal And Installation >> Ignition Coil-On-Plug >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford F-350 Super Duty and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the Air Cleaner (ACL) outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION & FILTERING .
  2. Remove the intake air resonator. For additional information, refer to INTAKE AIR DISTRIBUTION & FILTERING .
  3. Disconnect the 8 ignition wires.
  4. Disconnect the 8 ignition coil-on-plug electrical connectors.
  5. Remove the 8 ignition coil-on-plug bolts.
    • To install, tighten to 10 Nm (89 lb-in).
  6. NOTE: When removing the ignition coil-on-plugs, a slight twisting motion will break the seal and ease removal.

    Remove the 8 ignition coil-on-plugs.

  7. NOTE: Verify that the ignition coil spring is correctly located inside the ignition coil-on-plug boot and that there is no damage to the tip of the boot.

    To install, reverse the removal procedure.

    • Apply a light coat of dielectric compound to the inside of the ignition coil boots.
scientia non olet · About LEMON Manuals