Removal and Installation
WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the driver air bag module. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM .
- Turn the steering wheel to the straight-ahead position.
- Remove and discard the steering wheel bolt.
- To install, tighten the new bolt to 48 Nm (35 lb-ft).
- Remove the steering wheel while routing the wires from the clockspring through the steering wheel.
- Tape the clockspring center rotor to the outer housing to keep it from rotating.
- To install, reverse the removal procedure.