Removal and Installation
WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Press the 5 position retaining tabs and rotate the lower cooling fan shroud upward until the position retainer tab locks into position.
- Detach the 2 lower radiator hose assembly retainers and position the lower radiator hose assembly aside.
- Remove the 4 nuts and position the stabilizer bar downward.
- To install, tighten to 48 Nm (35 lb-ft).
- Using the Fan Pulley Holding Wrench and the Fan Clutch Nut Wrench, remove the fan and fan clutch from the coolant pump pulley.
- To install, tighten to 133 Nm (98 lb-ft).
- If servicing the cooling fan or the cooling fan clutch, remove the 4 bolts and separate the cooling fan from the cooling fan clutch.
- To install, tighten to 7 Nm (62 lb-in).
- To install, reverse the removal procedure.