LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 71 (Instrument Panel And Console) >> Removal And Installation >> Instrument Cluster Finish Panel >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the steering column in the downward and rearward position.
  2. Remove the upper instrument panel center finish panel. For additional information, refer to INSTRUMENT PANEL FINISH PANEL - CENTER, UPPER .
  3. Remove the steering column opening trim panel.
  4. Remove the 4 instrument cluster finish panel screws.
    • Remove the tree type retainers for the gap hider.
  5. Remove the instrument cluster finish panel.
    • If equipped, disconnect the electrical connectors.
  6. To install, reverse the removal procedure.
    • Make sure to align the trim panel retaining clips to the adjacent retaining clip holes.
scientia non olet · About LEMON Manuals