LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 66 (Seat System - Seats) >> Removal And Installation >> Seat Cushion - Rear, Crew Cab >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the seat. For additional information, refer to SEAT - REAR, CREW CAB .
  2. Remove the 2 bolts from the back side of the center support.
    • To install, tighten to 50 Nm (37 lb-ft).
  3. Separate the 60 percent seat from the center support.
  4. Remove the screw and side latch shield.
  5. Remove the screw and cushion release handle.
  6. Pry the side shield to release the 3 clips and remove the side shield.
  7. Remove the 2 outboard cushion latch-to-cushion bolts and the cushion assembly.
    • To install, tighten to 33 Nm (24 lb-ft).
  8. Remove the outboard cushion latch lower mount bolt and the seat cushion latch assembly.
    • To install, tighten to 25 Nm (18 lb-ft).
  9. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals