Seat - Front, 20 Percent: Installation
WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Before installation, make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.
- Install the 20 percent seat retainers in the following sequence.
- Position the safety belt anchor. Install the 20 percent seat-to-floor RH rear nut.
- Tighten to 63 Nm (46 lb-ft).
- Position the safety belt buckle. Install the 20 percent seat-to-floor LH rear nut.
- Tighten to 63 Nm (46 lb-ft).
- Install the two 20 percent seat-to-floor front nuts in any sequence.
- Tighten to 55 Nm (41 lb-ft).
- Position the safety belt anchor. Install the 20 percent seat-to-floor RH rear nut.
- For seats without under seat storage, reposition the cushion cover and foam pad and engage the pin-type retainers.
- For 20 percent seats with under seat storage, install the utility tray.
- Install the front seats. For additional information, refer to SEAT - FRONT, BUCKET SEAT .