Removal and Installation
WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Before beginning any service procedure in this article, refer to Safety Warnings in
SERVICE INFORMATION
. Failure to follow this instruction may result in serious personal injury.
NOTE:
Removal steps in this procedure may contain installation details.
- Tighten to 10 Nm (89 lb-in)
- To install, reverse the removal procedure.
- Carry out the auto-configuration sequence to program the heated seat module for use with a dual momentary switch.
- Start the vehicle and push the low button on either heated seat switch.
- Operate the heated seats, monitor the indicators and verify the system is operating correctly in high and low.