LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 66 (Seat System - Seats) >> Disassembly And Assembly >> Seat Cushion - Rear, SuperCab >> Disassembly and Assembly

Disassembly and Assembly

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If both seat cushions need to be disassembled, repeat steps for other side.
  1. Remove the seat cushion. For additional information, refer to SEAT - REAR, SUPERCAB .
  2. Remove the 60 percent or 40 percent seat cushion. For additional information, refer to SEAT CUSHION - REAR, SUPERCAB .
  3. Remove the screw and latch handle cover.
  4. Remove the support-to-latch bolts.
    1. Remove the upper support-to-latch bolt.
      • To install, tighten to 33 Nm (24 lb-ft).
    2. Remove the lower support-to-latch bolt.
      • To install, tighten to 25 Nm (18 lb-ft).
  5. Remove the RH latch cover.
  6. Remove the latch-to-cushion frame bolt.
    • To install, tighten to 33 Nm (24 lb-ft).
  7. Release the cushion trim cover J-clip.
    Fig 1: Locating Cushion Trim Cover J-Clip
    G06764158Courtesy of FORD MOTOR CO.
  8. Invert and remove the cushion trim cover.
  9. Remove the cushion foam pad from the cushion frame.
  10. To assemble, reverse the disassembly procedure.
scientia non olet · About LEMON Manuals