Power Steering Pump Pulley: Removal

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The power steering pump and pulley are serviced as an assembly on vehicles equipped with a 6.7L diesel engine.

Remove the engine cooling fan shroud. For additional information, refer to ENGINE COOLING - GASOLINE ENGINES .
Rotate the accessory drive belt tensioner and remove the accessory drive belt from the power steering pump pulley.
Using the Power Steering Pump Pulley Remover, remove the pulley.
- Inspect the pulley for paint marks in the web area near the hub. If there are 2 paint marks, discard the pulley. If there is no paint or one paint mark, use a paint pencil to mark the web area of the pulley near the hub.
  
  Fig 1: Locating Power Steering Pump Pulley Remover
  Courtesy of FORD MOTOR CO.
NOTE: Installation of a new power steering pump pulley is necessary after being removed and installed 2 times, or pulley and/or pump failure may occur.

Using the Power Steering Pump Pulley Installer, install the power steering pump pulley.

Fig 2: Locating Power Steering Pump Pulley Installer
Courtesy of FORD MOTOR CO.