LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Four Wheel Drive (4WD) Systems) >> Removal And Installation >> Transfer Case Control Module (TCCM) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Disconnect the connectors from the Transfer Case Control Module (TCCM).
  3. Remove 2 nuts and the TCCM.
    • To install, tighten to 4 Nm (35 lb-in).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals