Removal and Installation
WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Only vehicles with a mechanical shift transfer case are equipped with a Mode Indication Switch (MIS).
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Disconnect the wiring harness connector.
- Remove the MIS switch.
- To install, tighten to 31 Nm (23 lb-ft).
- To install, reverse the removal procedure.