Removal and Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: It is not necessary to remove the driver air bag module during this procedure.

NOTE: When removing a steering wheel switch, disengage the outboard side of the switch first.

Using a suitable tool, such as a flat-bladed screwdriver, pry the steering wheel switch out of the steering wheel.
NOTE: Do not allow the electrical connector to fall back into the steering wheel.

Disconnect the electrical connector and remove the switch.
To install, reverse the removal procedure.