LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 50 (Steering Column Switches) >> Removal And Installation >> Steering Column Control Module (SCCM) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. If a new SCCM is being installed, connect the scan tool and upload the module configuration information from the original SCCM. For additional information on configuration, refer to PMI in MODULE CONFIGURATION .
  2. Remove the steering wheel rotation sensor. For additional information, refer to ANTI-LOCK BRAKE SYSTEM (ABS) & STABILITY CONTROL .
  3. Remove the steering column shrouds. For additional information, refer to STEERING COLUMN .
  4. Refer to exploded view(s) and any Warnings, Notices, Notes, Materials, Specifications and Special Tools. Items in the exploded views may not be listed in order of removal.
  5. To install, reverse the removal procedure.
    • If a new SCCM was installed, it must be configured (using vehicle as-built data or module configuration information retrieved earlier in this procedure). For additional information on configuration, refer to PMI in MODULE CONFIGURATION .
scientia non olet · About LEMON Manuals