LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 50 (Steering Column Switches) >> Removal And Installation >> Ignition Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering column shrouds. For additional information, refer to STEERING COLUMN .
  2. Place the steering column tilt lever in the unlocked position.
  3. Disconnect the ignition switch electrical connector.
  4. Press the 2 locking tabs and remove the ignition switch.
    Fig 1: Locating Ignition Switch Electrical Connector
    G06064039Courtesy of FORD MOTOR CO.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals