Circuit Deactivation Ignition Module (CDIM): Installation
WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the electrical connector.
- Position the CDIM and install the 2 pin-type retainers.
- If the CDIM is being installed new as a dealership option, the PCM must be enabled. For additional information, refer to the Extended Idle Shutdown Initialization General Procedure in ELECTRONIC ENGINE CONTROLS - DIESEL ENGINES .