DTC Charts
WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
BODY CONTROL MODULE (BCM) DTC CHART
| DTC | Description | Action |
|---|---|---|
| B1142:29 | Ignition Status 1: Signal Invalid | GO to PINPOINT TEST E . |
| B1310:12 | Run/Start Control: Circuit Short to Battery | GO to PINPOINT TEST G . |
| B1310:14 | Run/Start Control: Circuit Short to Ground or Open | GO to PINPOINT TEST C . |
| U300A:01 | Ignition Switch: General Electrical Failure | GO to PINPOINT TEST H . |
| All other DTCs | - | REFER to the Master DTC Chart in MULTIFUNCTION ELECTRONIC MODULES . |
CIRCUIT DEACTIVATION IGNITION MODULE (CDIM) DTC CHART
| DTC | Description | Action |
|---|---|---|
| B1342 | ECU is Faulted | INSTALL a new CDIM. REFER to Circuit Deactivation Ignition Module (CDIM) . |
| B1355 | Ignition Run Circuit Failure | GO to PINPOINT TEST F . |
| B1359 | Ignition Run/Acc Circuit Failure | GO to PINPOINT TEST F . |
| B2477 | Module Configuration Failure | CLEAR the DTC. CARRY OUT the self-test. RETRIEVE and RECORD any DTCs. If DTC B2477 returns, INSTALL a new CDIM. REFER to Circuit Deactivation Ignition Module (CDIM) . |
| U2050 | No Application Present | CLEAR the DTC. CARRY OUT the self-test. RETRIEVE and RECORD any DTCs. If DTC U2050 returns, INSTALL a new CDIM. REFER to Circuit Deactivation Ignition Module (CDIM) . |
STEERING COLUMN CONTROL MODULE (SCCM) DTC CHART
| DTC | Description | Action |
|---|---|---|
| B1007:09 | High-Beam Headlamp Switch: Component Failure | REFER to EXTERIOR LIGHTING . |
| B1008:09 | Wiper Mode Switch: Component Failure | REFER to WIPERS AND WASHERS . |
| B1051:09 | Front Washer Switch: Component Failure | REFER to WIPERS AND WASHERS . |
| B10A6:09 | Main Light Switch: Component Failure | REFER to EXTERIOR LIGHTING . |
| B1124:09 | Lamp Fade Control: Component Failure | REFER to EXTERIOR LIGHTING . |
| B1131:02 | Wiper Motor Module: General Signal Failure | REFER to WIPERS AND WASHERS . |
| B1131:08 | Wiper Motor Module: Bus Signal/Message Failure | REFER to WIPERS AND WASHERS . |
| B1131:49 | Wiper Motor Module: Internal Electronic Failure | REFER to WIPERS AND WASHERS . |
| B11D9:16 | Vehicle Battery: Circuit Voltage Below Threshold GO | to Pinpoint Test I. |
| B11D9:17 | Vehicle Battery: Circuit Voltage Above Threshold GO | to Pinpoint Test I. |
| B12F7:09 | Single Wipe Switch: Component Failure | REFER to WIPERS AND WASHERS . |
| B1368:11 | Adjustable Pedal Position Feedback Sensor: Circuit Short to Ground | REFER to HYDRAULIC BRAKE ACTUATION . |
| B1368:12 | Adjustable Pedal Position Feedback Sensor: Circuit Short to Battery | REFER to HYDRAULIC BRAKE ACTUATION . |
| B1369:09 | Pedal Adjustment Switch: Component Failure | REFER to HYDRAULIC BRAKE ACTUATION . |
| B137D:18 | Pedal Adjustment Motor: Circuit Current Below Threshold | REFER to HYDRAULIC BRAKE ACTUATION . |
| B137D:19 | Pedal Adjustment Motor: Circuit Current Above Threshold | REFER to HYDRAULIC BRAKE ACTUATION . |
| B137D:71 | Pedal Adjustment Motor: Actuator Stuck | REFER to HYDRAULIC BRAKE ACTUATION . |
| B137F:09 | Steering Wheel Left Switch pack: Component Failure | REFER to CRUISE CONTROL . |
| B137F:11 | Steering Wheel Left Switch pack: Circuit Short to Ground | REFER to CRUISE CONTROL . |
| B137F:17 | Steering Wheel Left Switch pack: Circuit Voltage Above Threshold | REFER to CRUISE CONTROL . |
| B1380:09 | Steering Wheel Right Switch Pack: Component Failure | Refer to the appropriate Information and Entertainment Systems article for the procedure. |
| B1380:11 | Steering Wheel Right Switch Pack: Circuit Short to Ground | Refer to the appropriate Information and Entertainment Systems article for the procedure. |
| B1380:17 | Steering Wheel Right Switch Pack: Circuit Voltage Above Threshold | Refer to the appropriate Information and Entertainment Systems article for the procedure. |
| B1D36:09 | Turn Indicator Switch: Component Failure | REFER to EXTERIOR LIGHTING . |
| C0051:09 | Steering Wheel Position Sensor: Component Failure | INSTALL a new steering wheel rotation sensor. REFER to ANTI-LOCK BRAKE SYSTEM (ABS) & STABILITY CONTROL . CLEAR the DTCs. REPEAT the self-test. |
| C0051:16 | Steering Wheel Position Sensor: Circuit Voltage Below Threshold | GO to PINPOINT TEST J . |
| C0051:17 | Steering Wheel Position Sensor: Circuit Voltage Above Threshold | GO to PINPOINT TEST J . |
| U1000:00 | Solid State Driver Protection Active-Driver Disabled: No Sub Type Information | REPAIR all other SCCM DTCs before addressing this concern. CLEAR the DTCs. REPEAT the self-test. |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | CARRY OUT Programmable Module Installation (PMI) using as-built data on the SCCM. REFER to MODULE CONFIGURATION . RETRIEVE SCCM DTCs. If U2100:00 returns, INSTALL a new SCCM. |
| U2101:00 | Control Module Configuration Incompatible: No Sub Type Information | This DTC sets if the steering wheel switches do not match the switch function configuration data in the SCCM. CHECK the part numbers in Ford Catalog Advantage™ or equivalent and CONFIRM the correct SCCM and steering wheel control switches are installed on the vehicle. |
| U3000:49 | Control Module: Internal Electronic Failure | INSTALL a new SCCM. CLEAR the DTCs. REPEAT the self-test. |