LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 47 (MULTIFUNCTION Electronic Modules) >> Removal And Installation >> Upfitter Relay Box >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the upfitter switch assembly. For additional information, refer to UPFITTER SWITCH .
  2. Remove the instrument panel steering column opening cover.
  3. Disconnect the 14A303 harness from the 14401 harness in-line connector.
  4. Remove the ground terminal screw and position the 14A303 harness ground terminal aside.
    • To install, tighten to 12 Nm (106 lb-in).
  5. Remove the 2 screws and the upfitter relay box and harness assembly.
    • To install, tighten to 4 Nm (35 lb-in).
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals