LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (Information Center - Instrumentation, Message Center, And Warning Chimes) >> General Procedures >> Belt-Minder® Deactivating/Activating >> Deactivating/Activating

Belt-Minder® Deactivating/Activating: Deactivating/Activating

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch to the RUN position (do not start the engine).
  2. Wait until the safety belt warning indicator turns off (approximately 1 minute).
  3. NOTE: Step 3 must be completed within 30 seconds after the safety belt warning indicator turns off.

    At a moderate rate, buckle then unbuckle the driver safety belt 3 times, ending with the safety belt in the unbuckled state.

    • After this step, the safety belt warning indicator illuminates for 3 seconds.
  4. NOTE: The buckle/unbuckle sequence may not be counted if completed too fast. Wait approximately 2 seconds after each sequence.

    Within 10 seconds after the safety belt warning indicator turns off, buckle then unbuckle the safety belt.

    • This disables the Belt-Minder® feature, if it is currently enabled. As confirmation, the safety belt warning indicator flashes 4 times per second for 3 seconds.
    • This enables the Belt-Minder® feature, if it is currently disabled. As confirmation, the safety belt warning indicator flashes 4 times per second for 3 seconds followed by another flash sequence of 4 times per second for 3 seconds.
  5. After confirmation, the deactivation/activation procedure is complete.
scientia non olet · About LEMON Manuals