Removal and Installation
WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Remove the 4 stabilizer bar bracket nuts and the 2 stabilizer bar brackets.
- Discard the nuts.
- To install, tighten the new nuts to 48 Nm (35 lb-ft).
- Position the stabilizer bar to access the bushing.
- Remove the bushing.
- To install, reverse the removal procedure.