LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 41 (Front Suspension (RWD)) >> Removal And Installation >> Wheel Studs - Dual Rear Wheel (DRW) >> Installation

Wheel Studs - Dual Rear Wheel (DRW): Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the new wheel stud, aligning the serrations in the wheel extension made by the original wheel stud.
    Fig 1: Positioning Wheel Stud
    G07966960Courtesy of FORD MOTOR CO.
  2. NOTE: Make sure to use washers that have an ID that is larger than the OD of the wheel stud serrations. Use enough washers (approximately 4) to allow the wheel stud to fully seat against the hub flange.

    Place 4 washers over the outside end of the wheel stud and thread a standard wheel nut with the flat side against the washers. Tighten the wheel nut until the wheel stud seats against the back side of the wheel extension.

    Fig 2: Locating Wheel Nut And Washers
    G06064890Courtesy of FORD MOTOR CO.
  3. Remove the wheel nut and washers.
  4. Install the wheel and tire. For additional information, refer to WHEELS AND TIRES .
scientia non olet · About LEMON Manuals