Exhaust Intermediate Pipe - Gasoline Engines: Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

Position the exhaust intermediate pipe into the muffler and then onto the resonator.
If equipped, connect the exhaust intermediate pipe isolator.
Connect the front muffler isolator.
Make sure the button on the resonator is fully inserted into the button slot on the exhaust intermediate pipe and tighten the resonator-to-exhaust intermediate pipe Torca® clamp.
- Tighten to 55 Nm (41 lb-ft).
  
  Fig 1: Locating Tab On Exhaust System Pipe Notch
  Courtesy of FORD MOTOR CO.
Make sure the button on the exhaust intermediate pipe is fully inserted into the button slot on the muffler and tailpipe and tighten the exhaust intermediate pipe-to-muffler and tailpipe Torca® clamp.
- Tighten to 55 Nm (41 lb-ft).
  
  Fig 2: Locating Tab On Exhaust System Pipe Notch
  Courtesy of FORD MOTOR CO.