DTC P0330: Knock Sensor 2 Circuit (Bank 2)
WARNING: This page does not describe the selected car, but rather 25 other vehicles, including the 2013 Lincoln Navigator, 2013 Lincoln MKZ, 2013 Lincoln MKX, 2013 Lincoln MKT, and 2013 Lincoln MKS. However, it is still accessible from the selected car via links, so may be relevant.
DTC P0330: KNOCK SENSOR 2 CIRCUIT (BANK 2)
| Description: | The knock sensor (KS) detects vibrations upon increase and decrease in engine RPM. The KS generates a voltage based on this vibration. This DTC sets if the voltage goes outside a calibrated level. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | A KS voltage greater than 0.5 volt with the ignition ON, engine OFF, indicates a concern is present. The vehicle may need to be driven for several minutes to set this DTC. |
||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST DG . | ||