Seat Cushion Cover - Manual: Installation

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The lower anchors and tethers for children and child safety seat tether anchor must be accessible through the trim cover.

Position the cushion cover to the cushion foam pad and attach the retainers.
Secure the cushion trim cover retainers to the cushion frame.
Install the floor latch cover and screw.
Install the load floor panel.
- Install the 2 screws on each side at the bottom of the load floor panel.
Install the pivot release handle and attach the pivot release cable and casing.
Install the cushion handle and the 2 screw(s).