Seat Backrest Cover - Manual: Installation
WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
- Install the backrest trim cover.
- Route the strap through the trim cover.
- Install 3 rows of 3 hog rings.
- Install the pivot bolt.
- Tighten to 54 Nm (40 lb-ft).
- Secure the backrest cover inner J-clips, close the trim cover and secure the lower J-strip.
- Secure the backrest cover upper J-clip under the head restraint.
- If removed install the RH seat outboard pivot cover.
- Install the LH seat outboard pivot cover.