Safety Belt Shoulder Height Adjuster: Installation
WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
- Install the safety belt shoulder height adjuster in the following sequence.
- Engage the safety belt shoulder height adjuster T-tab to the B-pillar sheet metal.
- Rotate the top of the safety belt shoulder height adjuster up 90.
- Install the safety belt shoulder height adjuster bolt.
- Tighten to 40 Nm (30 lb-ft).
-
NOTE: Before installation, make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.
Position the D-ring and install the bolt.
- Tighten to 40 Nm (30 lb-ft).
- Install the B-pillar trim panels. REFER to B-PILLAR TRIM PANEL .