Video Camera: Removal

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

Remove the liftgate trim panel. REFER to LIFTGATE TRIM PANEL .
NOTE: LH side shown in illustration, RH side similar.

Open the rear liftgate and remove the LH and RH liftgate body moulding nuts.
1. To install, tighten to 3 Nm (27 lb-in).
Remove the 4 liftgate body moulding bolts and remove the liftgate body moulding.
1. To install, tighten to 3 Nm (27 lb-in).
2. Disconnect the electrical connector.
Remove the rear video camera screw and retainer, remove the rear video camera.
1. Disconnect the electrical connector.