Network Message Chart
WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
BCM NETWORK INPUT MESSAGES
| Broadcast Message | Originating Module | Message Purpose |
|---|---|---|
| Steering angle count | SCCM | Used to create the vehicle intended path on video display. Sent to the video camera via the LIN circuit. |
| Transmission in reverse | PCM TCM | Used to enable the video display. Sent to the video camera via the LIN circuit. |
| Parking aid range to object | PAM | Used to highlight the zone where an object is detected. Sent to the video camera via the LIN circuit. |
| Backup camera commands | APIM | Used to command the static and active guidelines status, zoom level and object distance Sent to the video camera via the LIN circuit. |
APIM NETWORK INPUT MESSAGES
| Broadcast Message | Originating Module | Message Purpose |
|---|---|---|
| Backup camera status | BCM | Used to display the video status for static and active guidelines, zoom level and object distance. |